rumars

Commands

The following commands can be entered into the console window to operate RuMARS.

battle, ba

Run the loaded warrior(s) in battle mode.

break <address>, br <address>

Toggle the breakpoint at the given address. You can use symbols and expressions to specify the address.

create, cr

Create a new warrior.

debug <level>

Set the verbosity of debug information. Levels 0 to 1 are supported.

exit

Exit the RuMARS.

focus <pid>, fo <pid>

Switch the focus to the loaded warrior with the given program ID.

goto <address>, go <address>

Set the current program counter to the given address. You can use symbols and expressions to specify the address.

list <address>, li <address>

Show the instruction at the given address in the core window. You can use symbols and expressions to specify the address.

load <filename>, lo <filename>

Load the redcode file with the given file name.

pcs

Show the program counters of the current program.

peek <address>, pe <address>

Print the instruction at the given address. You can use symbols and expressions to specify the address.

poke <address> <instruction>, po <address> <instruction>

Write the given instruction to the specified address.

restart, re

Restart all loaded warriors.

run [<cycles>], ru [<cycles>]

Run the loaded warriors until the given cycle count is reached or only one is left. No execution trace will be recorded.

save <filename.red> [<start address>] [<end_address>], sa <filename.red> [<start address>] [<end address>]

Save the whole core or the instructions within the specified address range to the given file.

step, st

Execute one instruction for all loaded warriors. The execution trace of the instructions will be shown in the register window.

This site is open source. Improve this page.